EN
TROUBLESHOOTING
The treadmill won’t switch on:
1 - Check that the power cable is plugged into a working wall socket (to check if the wall socket works, plug in a lamp or other
electrical appliance).
2 - Check that the power cable is plugged into a properly earthed wall socket. If you need an extension cable, only use a 1 mm² (size
14) 3 conductor cable that is no longer than 1.5m (5ft).
3 - Having connected the power cable, make sure that the key is properly inserted in the console.
4 - Check the switch on the treadmill frame, near the power cable. If the switch is sticking out, as illustrated, the switch has tripped.
To turn the switch back on, wait 5 minutes then press the switch.
The treadmill turned itself off during use:
1 - Check the switch (see diagram below). If the circuit breaker has tripped, wait 5 minutes then press the switch.
2 - Make sure that the power cable is plugged in.
3 - Remove the key from the console. Re-insert the key in the console.
4 - If the problem persists, contact the after-sales service team (see the last page of this manual).
The displays on the console stay lit up when you remove the key from the console:
The console is fitted with a demo mode, designed to be used when the treadmill is displayed in store. If the displays stay lit up when
you remove the key from the console, demo mode is probably switched on. To switch off the demo mode, press and hold the «STOP»
button for a few seconds. If the displays are still lit, refer to the INFORMATION MODE paragraph to switch off demo mode.
The belt slows down when you walk on it:
1 - If you need an extension cable, only use a 1 mm² 3 conductor cable that is no longer than 1.5m.
2 - If the belt is over-tightened, treadmill performance may be affected and the belt may become damaged. Remove the key and
UNPLUG THE POWER CABLE. Using the hex key, turn both roller bolts anticlockwise a quarter turn. When the belt is correctly
tightened, you should be able to raise each edge of the moving belt 2 or 3 cm above the walking platform. Be sure to keep the
treadmill belt centred. Then, plug in the power cable, insert the key and turn on the treadmill for a few minutes. Repeat the
process until the moving belt is correctly tightened.
3 - If the problem persists, contact the after-sales service team (see the last page of this manual).
The incline on the treadmill doesn’t change properly:
With the key inserted in the console, press on one of the incline keys. When changing the incline, remove the key from the
console. After a few seconds, re-insert the key. The treadmill will automatically lift itself up to the maximum incline and the return
to minimum level. In doing so, the incline system will recalibrate.
Motor noise when switching on the treadmill:
If the treadmill was switched off during an incline phase, switching it on will generate automatic calibration of the incline system.
This will result in the motor making a noise without the belt moving and the display of 2 bars on the control screen. The running
platform will automatically rise up to its maximum level before coming down again. You can then use the treadmill as normal.
(24 pages)
(23 pages)
(24 pages)
(23 pages)
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels